‘Crucial’ step to achieving a ‘smooth’ and ‘consistent finish’ when painting ceilings

0
70

Doing the job of painting yourself is often much cheaper than hiring a professional to do the job. It may require a little more research and planning in advance, but the results often look the same. According to Dulux, the use of unloaded rollers while the paint is still moist is “important” in achieving a great finish.

DIY experts shared that the first step to damaging the ceiling is to “prepare” the room.

They say: “Every good project starts with proper preparation.

“So clean up your area, put down the drop sheet, and then grab yourself a ladder, brush, tape, rollers and extension poles and trays.

This includes removing furniture from the room, moving away from the walls, reaching the edges, covering the floor, and covering everything the British don’t want to scatter with dust sheets.

People can use Hessian dust sheets, but old bed sheets work as well, at no extra cost – remove all bright shades and possible lighting fixtures to fit the edges when painting.

Read more: Grand Design: Couples change their minds to “11th hour” at a £ 300,000 home

Next, you need to mask the edges of the ceiling to prevent paint from sticking to the joint walls.

Use a decorator tape mask from the cove for those who have an area where the ceiling joins the wall or something.

DIY personnel are advised to paint the corving at the same time. In that case, mask the area where the corving joins the wall.

Once the walls were masked and clean, it was time to paint.

Experts continue as follows: “Start by cutting in a place that the rollers cannot reach, such as a vertical wall.

It’s important to roll in as deeply as possible into the previously brushed section.

The master of painting added: “Most of the ceiling is complete, so you can start painting while it’s still damp.

“This is an important step in achieving a smooth and consistent finish.

“Use of unloaded rollers starts in the upper left corner of the ceiling and pulls straight and slowly toward you without pressure.

“The lightness of the touch prevents the formation of new brush strokes. Repeat this action, with a few last moves, and the rollers scrape off the lines created by the previous stroke.”

If the ceiling needs to be applied twice, wait 2 hours for the first application to dry, then start with step 4 and cut the ceiling again.

LEAVE A REPLY

Please enter your comment!
Please enter your name here